| Command |
$AA5VV |
| Description |
Set channel enable/disable status |
| Syntax |
$AA5VV[CHK](cr)
| $ |
a delimiter character |
| AA |
address of setting module (00 to FF) |
| 5 |
command for setting channel enable/disable status |
| VV |
a
two-digit hexadecimal value, wherer bit 0 is corresponds to channel 0,
bit 1 corresponds to channel 1, etc. When bit is 1, it deontes the
channel is enable,and 0 denotes the channel is disable. 00 is all
disabled and FF is all enabled. |
| [CHK] |
2 characters of Checksum |
| (cr) |
Character Return(0x0D) for denote the end of command |
|
| Response |
| Valid Command |
!AA[CHK](cr) |
| Invalid Command |
?AA[CHK](cr) |
Syntax error or communication error may get no response.
| ! |
delimiter for valid command |
| ? |
delimiter for invalid command. |
| AA |
address of response module (00 to FF) |
| [CHK] |
2 characters of Checksum |
| (cr) |
Character Return(0x0D) for denote the end of response |
|
| Example |
| Command |
$0150F |
| Response |
!01 |
| Description |
Set address 01 to enable channel 0, 1, 2, 3 and disable channel 4, 5, 6, 7, response success. |
|
| Reference |
$AA6
|
|