+===============================================+
|       DCON Utility    Version : 5.2.3          
|       Release Date    30 May 2012             
+===============================================+

New Support Modules:
1. Added support for I-87016W , I-87084W and I-87088W modules when used
     with RU-87Pn/USB-87Pn and ET-87Pn Unit.
2. Added support for tM-AD5, tM-AD5C and tM-P3POR3 modules.
3. Added support for ZB-2026 modules.
4. Added support for M-7002, M-7017HL, M-7024R, M-7061 and M-7066.
5. Added support for I-7017HL module


Modifications:	
1. Added "User defined type code" function to MODBUS protocol for M-7005
2. Added calibration parameters for M-7005 firmware A3.7 or later versions.
3. DCON Utility will no longer enable watchdog after user resets watchdog.
4. Added rising or falling edge setting for I-87026PW DI counter.

  
Fixed Bug:
1. Using 756x converter,data was sometimes shown incorrectly in MODBUS:
     Affected modules: M-7000, tM-7000 and etc MODBUS protocol modules
     Description:
       Data fixed the issue where was sometimes shown incorrectly 
       and sometimes shown normally. This was a communication issue 
       in MODBUS protocol only when using a USB to RS-485 converter,
       for example I-7560, I-7561 or tM-7561.
2. Slot Status was shown "Time Out Error" on RU-87Pn:
     Affected modules: All I-87KW high profile modules
     Description:
       When Utility connects to RU-87Pn via XPAC or WinPAC COM port,
       the Slot Configuration Status was shown "Time Out Error" 
       on RU-87Pn configuration form. 
       After user clicks "Configure" button to configure modules then exit,
       it will also caused  "Time Out Error"
       (Users also need to update DCON_CE_WP.exe or DCON_CE_XP.exe 
       to 506 version to prevent this.)
      DCON_CE_WP.exe can be found at 
      ftp://ftp.icpdas.com/pub/cd/winpac/napdos/wp-8x4x_ce50/system_disk/tools/dcon_ce/
      DCON_CE_XP.exe can be found at 
      ftp://ftp.icpdas.com/pub/cd/xp-8000-ce6/system_disk/tools/dcon_ce/
3. 87018 CH: CJC is unable to set for 87Pn to configure module:
     Affected modules: I-87018W and I-87018RW
     Description:
       Unable to set the channel CJC for the 87018 serial modules 
       in the configuration settings for the RU-87Pn,
       USB-87Pn and ET-87Pn Auto Configuration 
       when using thermocouple type code.  
4. AI will show "Error" after exiting calibration.
     Affected modules: All 17 and 18 serial modules, 
       example I-7017, M-7017, I-87018, I-87018W and etc modules
     Description:
       After user clicks "Calibration" and exit calibration dialog, 
       the values of Analog Input was shown "Error" 

About more detailed release history and Information , please refer 
ftp://ftp.icpdas.com.tw/pub/cd/8000cd/napdos/driver/dcon_utility

Copyright @ 2012 by ICP DAS Co., Ltd. All rights are reserved.