\PIODA16
   for PIO-DA16, PIO-DA8, PIO-DA4

There are about demo program given as follows:

>>>>> DEMO
ĦE DEMO1.EXE: D/O demo program
ĦE DEMO2.EXE: D/I/O demo program
ĦE DEMO3.EXE: Single interrupt source (initial high)
ĦE DEMO4.EXE: Single interrupt source (initial low)
ĦE DEMO5.EXE: Two interrupt source
ĦE DEMO6.EXE: Waveform generator without calibration
ĦE DEMO7.EXE: Waveform generator with calibration
ĦE DEMO8.EXE: D/A hex value output without calibration
ĦE DEMO9.EXE: D/A hex value output with calibration
ĦE DEMO10.EXE: Save EEPROM data to file
ĦE DEMO11.EXE: Download EEPROM data from file


>>>>> Calibration
ĦE DEMO12.EXE: User software calibration
ĦE DEMO13.EXE: Factory calibration
Each PIO-DA16/DA8/DA4 Series card is already fully calibrated when shipped from the factory,
so it is usually unnecessary to calibrate the board again unless the accuracy is lost.