/****************************************************************************************/
/*                                                                                                            */
/*  PCI-1800/1802 LabVIEW v85 and later Development Toolkit                     */
/*         (Supports LabVIEW version 8.5 ~ 2011)                                           */ 
/*                                                                                                             */
/*  Version : 2.34.00                                                                                   */
/*  Update  : DEC 2011                                                                              */
/*  Support Card: PCI-1800L/H, PCI-1800LU/HU,                                           */
/*                       PCI-1802L/H, PCI-1802LU/HU                                           */
/*  Support OS :  Windows 2000 and XP/Vista/2003/2008/7 32/64-bit version. */
/*                                                                                                            */
/***************************************************************************************/

Please follow these steps:

1.Install the driver for PCI-1800/1802
 (CD:\NAPDOS\PCI\PCI-180X\DLL_OCX\Driver)

2.Power-off the PC, plug in the card and then power-on the PC.
  
3.Install the LabVIEW toolkit  

4.Run \Diag\**.exe to check the card and driver are installed correct or not.

5.Refer to the demo programs and get the description of sub-vis
  from "PCI-1202_1602_180x_DLL_Software_Manual_eng.pdf" in 
  CD:\NAPDOS\PCI\PCI-180X\Manual.


Install the LabVIEW toolkit:

  a. The default path to install is c:\DAQPro\pci_180x_lv85
  b. In the folder are demo programs, P1802.llb, kernel32.llb and this readme.txt.
  c. The demo programs list is as follows


------------------- demo1 & demo2 ---------------------------
. D/I/O, D/A, A/D polling, general test
. demo1 --> for single board, demo2 --> for two board


------------------- demo3 & demo4 ---------------------------
. A/D software-trigger and pacer-trigger demo
. demo3 --> for single board, demo4 --> for two board


------------------- demo5 & demo6 ---------------------------
. M_Function_1 demo
. demo5 --> for single board, demo6 --> for two board
------------------- demo7 & demo8 ---------------------------
. M_Function_2 demo
. demo7 --> for single board, demo8 --> for two board
------------------- demo9 & demo10 --------------------------
. M_Function_3 demo
. demo9 --> for single board, demo10 --> for two board


------------------- demo11 & demo12 -------------------------
. MagicScan function demo
. demo11 --> for single board, demo12 --> for two board


------------------- demo13 & demo14 -------------------------
. Continuous capture function demo
. demo13 --> for single board, demo14 --> for two board


------------------- demo15 ----------------------------------
. D/I/O test for board number identification


------------------- demo16 ----------------------------------
. Performance evaluation for single board


------------------- demo17 ----------------------------------
. MagicScan demo1 for single board, scan sequence=4->3->5
------------------- demo18 ----------------------------------
. MagicScan demo2 for single board, scan 32 channel, show 0/1/15/16/17


------------------- demo19 ----------------------------------
. A/D Calibration for single board

------------------- demo23 ----------------------------------
. external post-trigger demo, single board
. for PCI-180X
------------------- demo24 ----------------------------------
. external pre-trigger demo, single board
. for PCI-180X
------------------- demo25 ----------------------------------
. external middle-trigger demo, single board
. for PCI-180X