~AASi4PS

Reads enable/disable status of power on value of DO or DIO module in specific slot of the I-8000 system.

~AASi4PS[CHK](cr)

~	a delimiter character
AA	address number of the I-8000 system. AA= 00 ~ FFh
Si	slot number of the module. i = 0 ~ 3 or 0 ~ 7
4	command for read PowerOn Value / Safe Value
PS	power on value status
[CHK]	2-characters of Checksum
(cr)	Character Return(0x0D) for denote the end of the command

Valid Command	!AAS[chk](cr)
Invalid Command	?AA[CHK](cr)

Syntax error or communication error may get no response.

!	delimiter for valid command
?	delimiter for invalid command
AA	address number of the I-8000 system
S	power on value status. S: 0= disable, 1= enable
[CHK]	2 characters of Checksum
(cr)	Character Return(0x0D) for denote the end of the response

If any channel of the DO or DIO module is configure for the analog input alarms then this command is no effect to the specified channel . The channel is used for analog input alarms always can not configure again unless it is disconnect. Refer to : Analog Input Alarm

Command	~01S74PS
Response	!010(cr)
Description	Power on value of DO or DIO module in slot7 of the I-8000 system (address=01h) is disabled.

DO or DIO modules