Command $AAT2
Description Read the I/O module type  from the specified I-8000 system
Syntax $AAT2[CHK](cr)
$ a delimiter character
AA 2-characters HEX module address for the specified I-8000 system ,Range from 01 to FFh
T Command for read I/O module name.
2 Command for read I/O module type.
[CHK] 2-characters of Checksum
(cr) Character Return(0x0D) for denote the end of command
Response
Valid Command >TTTT[chk](cr) or >TTTTTTTT[chk](cr) 
Invalid Command ?AA[CHK](cr)
Syntax error or communication error may get no response.
> delimiter for valid command
? delimiter for invalid command
AA 2-characters HEX module address
T T=1 for 8K module,T=0 for 87K module,T=F for none module
[CHK] 2-characters of Checksum
(cr) Character Return(0x0D) for denote the end of response
Example
Command $01T2
Response >0110FF11(cr)
Description The example reads the specified I-8000 at address 01h.  This means the I-8000 system contains two 87K modules at slot 0, slot 3 and four 8K modules at slot 1,slot 2, slot 6, slot 7 and at slot 4 ,slot 5 without any modules. .


Modules I-8410,I-8810,I-8430,I-8431,I-8830,I-8831,I-8KE4,I-8KE8


Back to Previous Page