Note:These Command Just for Slave
I-8000 Series
Command $AAE1
Description Read the error status of the slot 4 to 7 from the specified I-8810 system
Syntax $AAE1[CHK](cr)
$ a delimiter character
AA 2-characters HEX module address for the specified I-8000 system
,Range from 01 to FFh
E1 Command for read the system error status,slot 4 to 7.
[CHK] 2-characters of Checksum
(cr) Character Return(0x0D) for denote the end of command
Response
Valid Command
!AAS4S5S6S7[chk](cr)
Invalid Command
?AA[CHK](cr)
Syntax error or communication error may get no response.
! delimiter for valid command
? delimiter for invalid command
AA 2-characters HEX module address
S4~S7 represent the error status of Slot 4 to 7
for I-8810 system.
[CHK] 2-characters of Checksum
(cr) Character Return(0x0D) for denote the end of response
Example
Command
$01E1
Response
!0101000000(cr)
Description
The example reads the error codes from the specified I-8810
system at address 01h. This means specified I-8810 system
contains a error status code in slot 4.
That is Span Calibration error.
Error Code
Error Code
Error Message
00h
No Error
01h
Span Calibration error
04h
Zero Calibration error
08h
Data Read Error
10h
CJC Read Error
20h
EEPROM error
Modules
I-8410,I-8810,I-8430,I-8431,I-8830,I-8831,I-8KE4,I-8KE8