I-8000 Command Sets

Note:These Command Just for Slave I-8000 Series(I-8410,I-8810)

Command

$AASiARRFF

Description

This command set the input range and data format of the analog data input module to the specified Slot in the I-8000 system.

Syntax

$AASiARRFF[CHK](cr)

$	a delimiter character
AA	2-characters HEX module address for the specified I-8000 system ,Range from 01 to FFh
Si	Specified slot number. i = 0 to 3(4 slots) or i = 0 to 7(8 slots)
A	Command for set the input range, data format of the analog input module
RR	Input range code Type
FF	Data format code Format
[CHK]	2-characters of Checksum
(cr)	Character Return(0x0D) for denote the end of command

Response

Valid Command	!AA[chk](cr)
Invalid Command	?AA[CHK](cr)

Syntax error or communication error may get no response.

!	delimiter for valid command
?	delimiter for invalid command
AA	2-characters HEX module address
[CHK]	2-characters of Checksum
(cr)	Character Return(0x0D) for denote the end of response

Example

Command	$01S0A0000
Response	!01(cr)
Description	The Analog Data input Module in slot 0 of the I-8000 system at address 01h that configuration is +/-15mV input range and engineering unit data format. The response indicates the command is valid.