Analog Input Input Channel 8 differential/16 single-ended  input channels
Input Type
+/- 1.25V, +/- 2.5V, +/- 5V, +/- 10V
+/- 20mA
(with external 125 Ohms resistor)
Sampling Rate 100K sample rate for single channel in polling mode,
50K sample rate for single channel in interrupt mode,
10K sample rate for 8 channels scan in interrupt mode.
Accuracy +/-0.1%
Common Mode Rejection typic 86dB
Voltage Input Impedance 20/200K/20M Ohms (Jumper Select)

200K(Default)
Overvoltage Protection -35V to +35V maximum
Isolation Voltage 3000Vrms
LED Display 1 LED as Power indicator
16 LEDs as High/Low Alarm signals
Power Requirement DC +5V, 480mA maximum


I-8017HS Block Diagram


I-8017HS Block Diagram


Voltage Input Wiring I-8017HS Voltage Input Wiring
Current Input Wiring I-8017HS Current Input Wiring
Screw wire into I-8017HS Screw wire into I-8017HS


Jumper position i-8017HS jumper position
  
JP2: default setting :

Differential Input		 i-8017HS JP2 (default setting : differential input)
  
JP3+ JP4
(Input impedance setting jumper)

Default : 200K Ohm

JP3 & JP4 should set on the same value, and input impedance
= 2 * setting value		 i-8017HS JP3+4 (input impedance default setting : 200K Ohm)


I-8017HS Dimention


Back to Previous Page